RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 34

Slide the tubular motor into the awning shaft (Fig. 4 )
STOP
1. First slide the catch (10) into the awning shaft (11).
Preparation for use of precision tubes (Figures
IMPORTANT
◆ Please only use precision tubes made from aluminium.
4.a
4.b
4.c
34
Never knock the motor (9) with force
into the awning shaft (11).
Doing so will cause serious damage.
ALUMINIUM
RolloTube I-line Sun Medium
1 
IMPORTANT
The set button (7) for the tubular motor must be easily accessible and the motor cable
(13) must be laid without kinking.
2. Subsequently press the tubular motor into the awning shaft (11) so
that the adapter (8) is fully inserted into the awning shaft (11).
IMPORTANT
In doing so, ensure that the adapter (8) does not slip off of the Magnetic ring (14)
on the drive head (6) during the assembly process. Otherwise malfunctions may occur,
see page 45.
- )
.a .e
1. Measure the distance between the adapter (8) and the rear third of the
catch (10) and mark this distance on the precision tube.
2. Saw a groove in the end of the precision tube 1 in order that the cam
 of the adapter (8) can be completely pressed into the tube.
NOTE
◆ There may not be any play between the groove 1 and the cam .
3. Slide the tubular motor (9) into the precision tube.
EN