RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 42

Automatically setting the upper end point and manually setting the lower end point
1.
▲ ▼
2.
3.
or
SET
4.
or
SET
5.
or
SET
6.
42
The awning will first retract to the upper stop until the tubular motor switches off automatically.
IMPORTANT
Never interrupt the sequence while the process is running. The awning must retract without interruption.
Subsequently the drive shifts the awning in the opposite direction.
Press and hold the corresponding set button* until the lower end point is reached.
on the motor, the cord switch device (20) or the external switch.
*
Release the set button as soon as the awning has reached the desired position.
The motor stops and the lower end point is stored.
You can correct the lower end point in small steps by briefly pressing the set button.
IMPORTANT
In the event that a malfunction occurs during configuration, e.g. in the event that the tubular motor only runs for a single rotation even when
the set button is pressed, it is unlikely that the tubular motor is faulty. Possibly the adapter (8) has slipped off of the drive head (6).
Check and, if necessary, correct the positioning of the adapter (8), see page 45.
NOTE
In the event that the end point configuration fails, you must reset the tubular motor to the factory setting (see page 44), in order to repeat
the process.
Finally, disconnect the tubular motor from the mains for a few seconds. Subsequently, the tubular motor is ready
for operation.
NOTE
The fabric relief and tensioning systems are only active if the end points have been configured as described above.
IMPORTANT
◆ The set lead (j) must be connected to neutral (f) after configuration of the end points.
EN