RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 38

The motor cable (Figure k)
11
Electrical connection of the tubular motor (Fig. l ),
Control of a drive from a single point with a 1-pole switch / button
12
(a)
(b)
(c)
38
(7)
(13)
L1
L1
N
PE
(h) (i)
(d)
(e) (f) (g) (j)
1. Connect the motor cable (13) to the connecting cable supplied by
means of a connector and make the connection according to the
following wiring configuration.
Colour scale for the motor leads (13)
= set lead
L1
=
L1 =
N = neutral
PE = earth
(7)
= Set button on tubular motor
* NOTE
The actual direction of rotation for the tubular motor and the awning
depends on the direction of installation and the wiring of the tubular
motor.
Note about releasing the plug connection
Use an appropriate tool (e.g. a small screwdriver) to loosen the plug connection.
Legend
(a) = set button (7)
(b) = Controller (e.g. 1-pole switch / button)
(c) =
Mains 230 V/50 Hz
(d) = Socket box
Pin assignment
(e) = PE
green/yellow
(f) = N blue
(g) = L1 black
(h) = (▲) black
(i) = (▼) brown
(j) =
white/grey (set lead)
IMPORTANT
◆ The set lead (j) must be connected to neutral (f) after configuration of the end points.
(white/grey)
(black) *
(brown) *
(blue)
(green / yellow)
EN