RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 43

Manually setting the upper / lower endpoints
1.
▲ ▼
2.
or
SET
3.
or
SET
4.
or
SET
Test run / modifying the end points
Check the configuration and allow the roller shutters to run in both
directions, until the end points switch off the motor.
Thermal protection
The tubular motors are designed for brief operation (approx. 4 mins).
If this period is exceeded, or if the equipment is switched over frequently, then the motor
may heat up and the thermal protection system will shut it off.
In this case, allow the motor to cool down for 20 minutes.
First set the switch / controller to upward travel (▲) / downwards travel (▼).
NOTE
In the event of incorrect direction of rotation, disconnect the lead from the mains and exchange wires L1
Press and hold the corresponding set button* until the desired end point is reached.
* on the motor, the cord switch device (20) or the external switch.
The awning retracts / extends.
Release the set button as soon as the awning has reached the desired position.
The motor stops and the upper / lower end point is stored.
You can correct the end point in small steps by briefly pressing the set button.
IMPORTANT
In the event that a malfunction occurs during configuration, e. g. in the event that the tubular motor only runs for a single rotation even when
the set button is pressed, it is unlikely that the tubular motor is faulty. Possibly the adapter (8) has slipped off of the drive head (6).
Check and, if necessary, correct the positioning of the adapter (8), see page 45.
NOTE
The end points are maintained permanently even in the event of power failure.
IMPORTANT
◆ The set lead (j) must be connected to neutral (f) after configuration of the end points.
Modifying the end points
Move the awning back to the centre position and begin the process again.
EN
and L1 .
43