RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 36

Mounting the roller shutter casing (Fig. 5 - 7 )
Drive bearing (as click bearing)
1. Screw the drive bearing (4) to the previously removed bearing block
(3) (see Fig. 5).
IMPORTANT
Mount the drive bearing (4) so that the bearing block (3) enables easy access to the
set button (7) on the tubular motor (9) at all times.
If excessively long assembly screws are used , the drive bearing (4)
may be bent or damaged (see Fig. 6) and below.
The assembly screws (2) must sit flush with the base plate (17) as otherwise the drive
bearing (4) may be bent and be pressed up in front of the base plate (17).
This applies particularly if the inner assembly holes are used on the base plate (17).
(17)
Preparing the awning for the electrical connection
and commissioning (Figure 8 )
1. Place the side cover (1) (if available) back onto the bearing block (3),
(see Fig. 8 ).
Release the ratchet straps from the joint arms.
2.
3. Finally, check that the installation work has been carried out properly.
36
2. Subsequently slide the bearing block (3) back onto the cross member
(18) of the awning until the drive bearing (4) fully engages on the
drive head (6) (see Fig. 7).
3. Check that the set button (7) on the motor (9) is easily accessible. Correct
the position of the drive bearing (4) on the bearing block (3) if necessary.
NOTE
The tubular motor can be fitted into the click bearing (4) in 4 positions. The motor can
be released from the click bearing (4) at any time by means of expanding the retaining
spring (5).
4. Finally screw the bearing block (3) back onto the cross member (18)
of the awning.
Drive bearing (all other bearing types)
(2)
The assembly of other bearing types is undertaken in the same way as in the previous
description. In doing so, pay attention to the special characteristics of the respective bearing
type, e.g. the connection between the drive head and the drive bearing with a cotter pin.
EN