Safety instructions
Maintenance and cleaning
The modules are maintenance-free. Please note the following points when
cleaning the housing:
S Before cleaning, disconnect all connections.
S Clean the housing with a soft, slightly damp (not wet!) cloth. Never use
solvent as this could damage the labeling or the housing.
S When cleaning, ensure that no liquid gets into the module or connections.
Outputs
If using outputs such as analog voltage, digital 5/24 V alarms or protocol sig
nals via CAN FD, EtherCAT, PROFINET or others of a module, particular at
tention must be paid to safety. Make sure that status or control signals cannot
initiate any actions that may pose a danger to persons or the environment.
Product liability
In the following cases, the protection provided for the device may be adversely
affected. Liability for device functionality then passes to the operator:
S The device is not used in accordance with the operating manual.
S The device is used outside the field of application described in this section.
S The operator makes unauthorized changes to the device.
Warning signs and danger symbols
Important instructions for your safety are specifically identified. It is essential to
follow these instructions in order to prevent accidents and damage to property.
Safety instructions are structured as follows:
WARNING
Type of danger
Consequences of non-compliance
Averting the danger
QuantumX
5
A02361_05_Z00_01 HBM: public