HBM QuantumX MX840B Bedienungsanleitung Seite 6

Safety instructions
General dangers of failing to follow the safety instructions
Every module is a state of the art device and as such is failsafe. The module
may give rise to residual dangers if it is inappropriately installed and operated
by untrained personnel. Any person instructed to carry out installation,
commissioning, maintenance or repair of the modules must have read and
understood the Operating Manuals and in particular the technical safety
instructions.
The scope of supply and performance of the modules only covers a small area
of measurement technology. In addition, equipment planners, installers and
operators should plan, implement and respond to the safety engineering
considerations of measurement technology in such a way as to minimize
residual dangers. On-site regulations must be complied with at all times. There
must be reference to the residual dangers connected with measurement
technology. After making settings and carrying out activities that are
password-protected, you must make sure that any controls that may be
connected remain in safe condition until the switching performance of the
module has been tested.
Conditions on site
For modules in the housing with degree of protection IP20:
S Protect the modules from dirt and moisture or the effects of weather such
as rain, snow, etc.
S The permissible relative humidity at 31
reduction to 50% at 40
S Make sure that the side ventilation openings are not covered.
For all modules:
S Do not expose the modules to direct sunlight.
S Please observe the permissible maximum ambient temperatures stated in
the specifications.
S Ensure there is adequate ventilation for installation in the BPX001 back­
plane.
4
o
C.
A02361_05_Z00_01 HBM: public
o
C is 80% (non-condensing); linear
QuantumX