Pixsys ATR144 Installationsanleitung Seite 79

GROUP G -
101
d. i .2.f.
Digital input 2 functioning.
diSab.
2t. sw.
2t.sw.i.
3t.sw.i.
4t.sw.i.
st./st.
rUn
ext.al.
HoLd
tune
au.ma.i.
au.ma.c.
act.tY.
A.i. 0
M. reS.
t.1.run
t.1. s.E.
- Digital input 2
d. i . 2
Digital Input 2 Function
Disabled (Default)
2 Setpoints Switch
2 Setpoints Switch Impulsive
3 Setpoints Switch Impulsive
4 Setpoints Switch Impulsive
Start / Stop.
Status of the controller, upon power-up,
depends on parameter 30 ini.s.
With the controller in STOP the alarms
remain active.
External alarm.
The controller goes on STOP and the
alarms will be disabled. The controller
does not return to START automatically:
for this operation, the user's intervention
is required.
Lock conversion
(stop all conversions and display values)
Enable / disable tuning if the parameter 36
tun. 1 is set on manu.
Automatic / Manual Impulse
(if enabled on parameter 29 A.MA. 1 )
Automatic / Manual Contact
(if enabled on parameter 29 A.MA. 1 )
Action Type.
Cooling regulation if D.I. is active,
otherwise heating reg.
Analogue Input 0. Set AI to zero
Manual reset. Reset the outputs if selected
as manual reset.
Timer 1 run.
The timer 1 counts with D.I. activated
Timer 1 Start End.
D.I. starts and stops the timer 1(impulsive)
User manual - ATR144 - 79