Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Turn choke to OFF position
3. Depress the primer pump, located under the
air cleaner cover, about 6 times until fuel
comes to the carburetor.
4. Pull the starter slowly until resistance is felt,
then pull sharply.
Be careful to accompany the handle well to
avoid a sudden return of it on the motor of the
machine.
5. After the machine has started, return the
choke to the ON position
6. Let the machine heat up for 2-3 minutes.
3. Hot engine start
1. Pour redémarrer la machine lorsque le
moteur est chaud, mettez le starter en position
ON
2. Pull the starter slowly until resistance is felt,
then pull sharply.
3. Let the engine run until it reaches a steady
speed.
4. Stop
WARNING! The cutter may
continue to rotate for a few
seconds after the machine
1. Release the throttle trigger and allow the
engine to idle.
2. Turn the on/off switch to the off (O) position.
If you feel unusual and excessive vibrations,
stop the machine immediately.
Perform checks to determine the cause.
USING A SPOOL OF THREAD
Refer to the safety instructions.
For any accessory replacement or
maintenance operation, it is essential to stop
the engine and disconnect the spark plug
suppressor.
1. wire feed
When it seems necessary to you, readjust the
length of the thread. This type of cut saves
time thanks to its "Tap and go" system. To
lengthen the nylon strands, strike the cutting
head on a hard, flat surface. The two nylon
threads will automatically be cut to the correct
length on the thread cutter present on the
protective casing.
2. Usage tips
• The line spool cuts the grass thanks to the
rotational force of the line. If you want to cut
the grass all at once, the rotational speed will
decrease due to the resistance and therefore
the quality of the cut will be poor. If there is
significant resistance, immediately pull the
spool away from the grass, rev the engine and
cut a smaller amount of grass at a time.
• It is advisable to cut the grass by advancing
gradually. It is imperative to perform circular
movements from RIGHT to LEFT.
• Cut the grass over a width of about 1.50 m
then move forward step by step, making
movements from right to left then vice versa.
USING THE METAL BLADE
Before using the machine with the metal blade,
we recommend that you check that the area to
be lightened does not contain stones, iron
wires or excessively thick plants (diameter
greater than 1 cm).
Using the brushcutter with the 3-tooth steel
blade will allow you to quickly clear up an area
where grass and brush have taken over. This
3-tooth blade is intended for cutting tall, dense
has stopped.
96
Werbung
