Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the automatic lubrication system does not
work, check and clean the oil filter and the oil
circulation areas of any obstructions. If the
automatic lubrication system still does not
work, contact our after-sales service.
The life of the chain as well as the bar
depends, in part, on the quality of the lubricant
used. Do not use old/reclaimed oil. Use only a
healthy lubricant specially designed for this
purpose. Store the lubricant in containers that
comply with the standards in force.
• Harness adjustment
Caution: Always use the
harness when using the
Fasten the harness as soon
as you have started the
engine and the engine is
idling. Stop the engine
before removing the
To prepare for any eventuality, when using a
harness: train to learn how to get out of the
machine quickly. During this exercise, do not
throw the machine on the ground, to avoid the
risk of damaging it.
brushcutter.
harness.
Detachment
In an emergency, pull the red tab, then remove
the machine by pulling it towards you. Be
especially careful to maintain control of the
machine at this stage. Do not allow the
machine to be thrown towards you or anyone
near the work area.
WARNING :
Losing control of the machine could cause
serious personal injury or DEATH.
STARTUP
1. Switching on
Warning: during operation, the
engine gives off odourless,
invisible and therefore very
dangerous gases. These
exhaust gases are toxic and
therefore fatal. Only use this
product outdoors. Indoor use
Never use the machine as a
brushcutter without the
cutting device guard.
The engine of your machine is a 2-stroke engine
that runs on a mixture of petrol and oil. Refer to
paragraph '5 Fuel and supplies: safe handling' for
the preparation of this mixture.
Before starting, thoroughly inspect the machine, the
fixing screws, possible fuel leaks and check that the
cutting device is well fixed and securely fastened.
Put the machine on a flat surface and put the cutting
head away from anything. Check that the tank cap
is correctly closed.
2. First use and cold engine start
1. Place the On/Off switch in the On (I)
position.
prohibited.
WARNING!
95
Werbung
