Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Handle adjustment
Unscrew the 2 parts of the handle. Position the
2 parts of the handle near the foam part of the
handle. Make sure that the notch (1) of the
handle is aligned with the notch (2) of the anti-
vibration support and that the rod (3) is located
to your left (for right-handers only). Firmly
tighten the handle to the bracket using the
screws.
Note: the use of the machine is only suitable
for right-handed people.
BRUSHCUTTER AND EDGER:
• Assembly of the blade protection device
Fix the protection device on the corner
transmission. To do this, place the protector
between the fixing plate and the flange, then
tighten the assembly using the 4 screws and
nuts provided.
Once fixed, the protective
device should not be removed
or disassembled for normal use
or for any maintenance.
• Assembly of the blade and the cutting
head
Warning!
- The use of unauthorized cutting devices
can cause serious injury. Always use an
original blade and cutting head.
- Always use cutting tools with a max. is
greater than the maximum rotational speed
of the shaft.
Your machine comes with a 3-tooth blade and
a string trimmer head. It can be mounted in two
configurations:
a) Brushcutter
1. Place the inner flange on the inner shaft
support.
2. Place the blade, outer flange, guard and nut
on the arbor. Make sure that the blade is
correctly positioned on the inner flange.
3. Rotate the blade by hand so that the hole in
the bevel gear and the hole in the inner flange
correspond.
92
Werbung
