Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Carefully tighten the fuel tank cap. Move to
start the engine (at least 3 meters from where
you refueled).
Never refuel in a confined room. Fuel vapors
accumulate at ground level (risk of explosion).
Transport and store fuel only in approved
containers.
Make sure that children cannot access the fuel.
Manual
It is forbidden to use the machine if it is not in
perfect working order – RISK OF ACCIDENT!
To prepare for any eventuality, when using a
harness: practice
to know how to get out of the machine quickly.
During this exercise, do not throw the machine
on the ground, to avoid
risk damaging it.
In case of emergency, imminent danger or to
clear a blockage or jam stop the motor
immediately – move the combined slider / stop
switch to the STOP or 0 position
Take special care on slippery ground – wet,
covered in snow or ice – as well as when
working on a hillside or on uneven ground etc.
– RISK OF SKID!
Pay attention to obstacles: tree stumps, roots –
TO AVOID THE RISK OF STRIPPING!
Work only from the ground, never climb on
unstable scaffolding – never on a ladder or
Cherry picker.
Particular care must be taken when working
with earmuffs – because danger signaling
noises (shouts, beeps etc.) are less
perceptible.
Take breaks in time so as not to risk reaching
a state of fatigue or exhaustion which could
LEAD TO A ACCIDENT !
Work calmly, thoughtfully – only in good
visibility and light conditions.
Take the necessary precautions to exclude the
risk of injuring other people.
When working in ditches, depressions in the
ground or confined spaces, always take care to
ensure sufficient ventilation – DANGER OF
DEATH FROM POISONING!
In case of nausea, headache, visual
disturbances (eg.
narrowing of the field of vision) or hearing,
dizziness or increasing lack of concentration,
stop work immediately – these symptoms can,
among other things, be caused by too much
exhaust gas concentration in the air
environment – RISK OF ACCIDENT!
Avoid unnecessary noise and exhaust
emissions. Do not leave the engine running
when the machine is not in use – accelerate
only to work.
Do not smoke while working or near the
machine – RISK
FIRE! Flammable gasoline vapors can escape
from the fuel system.
If the machine has been subjected to stresses
outside the scope of
normal use (e.g. if it has been subjected to
violent efforts, in the event of an impact or a
fall), before putting it back
running, it is essential to ensure that it is in
perfect working order.
Never work without the protective cover
suitable for
the machine and the cutting tool used – RISK
OF INJURY FROM THROWED OBJECTS!
Regularly remove grass and brush entangled
in the cutting tool socket – if clogged, clean the
cutting tool area or the protective cover.
Never use the multi-tool while in a tree.
Never work on unstable surfaces.
Before using the attachment, make sure that it
has reached its maximum speed.
BRANCH PRUNING
Before cutting a branch, ensure that:
1) Within the fall radius of the branch there are
no people or animals.
2) Choose the branch's fall direction so that it
can move away in the opposite direction.
3) Check that the outbound course is free of
obstacles.
4) To choose the direction of fall, take into
account the following variability factors:
a) Highly developed branching
82
Werbung
