Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Component of the
machine
Leaks, overflowing fuel
Fuel tank, air filter, fuel
filter
Engine speed adjusting
screw
Spark plug
Ventilation slots, cylinder
ventilation ribs
Silencer, anti-jamming
cable, muffler
Accelerator trigger, on/off
switch, clutch
cutting device
Bevel gear, gear
crankcase
Screws/nuts/bolts
Protect Carter from the
cutting device
Case #1: The engine does not start
To check
Fuel tank
Fuel filter
Carburetor adjustment screw
Spark plug
Spark plug fault wire
Case #2: The engine starts but stops immediately / has a hard time restarting
To check
TABLE OF SERVICE INTERVALS
Procedure
For use
Cleaning /
V
Dissolving
Check or clean
V
Adjust the
coasting speed
V
Cleaning and
adjusting
the spacing of
the electrodes
Cleaning
Cleaning
V
Replace if device
damaged
V
Lubricate
Tighten or
V
replace
Make sure of the
correct
V
confirmation
BREAKDOWN REPAIR
Possible causes
Bad fuel
Fuel filter clogged
Poor carburettor adjustment
- Faulty / damp spark plug
-
- Poor electrode spacing
-
Fault wire incorrectly connected
Possible causes
Every 25
Every 50
Every 100
hours
hours
hours
V
V
V
V
V
V
Empty the tank and use the correct type of
fuel
Cleaning
Adjust the engine idle speed
- Clean / dry the spark plug
-Adjust the spacing with a thickness
gauge
Reconnect the fault wire
Remark
Contact the after-sales
service if necessary
Have it replaced by the after-
sales service if necessary
Have the carburetor replaced
by the after-sales service if
necessary
Spacing : 0.6 - 0.7 mm
Replace the spark plug if
necessary
Does not apply to setscrews
Corrective action
Corrective action
100
Werbung
