Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Read the instruction manual carefully before using the machine and keep it
SAFETY INSTRUCTIONS
General guidelines
For correct use, read this instruction manual to
familiarize yourself with the operation of the
multi-function tool. Without this information,
you risk putting yourself in danger or injuring
others due to incorrect use.
It is recommended to lend the multi-tool only to
people who have used multi-tools before.
Always pass this manual on to them.
People using the tool for the first time should
ask the dealer to provide them with basic
instructions in order to familiarize themselves
with the operation of a thermal power cutter.
Children and young people under the age of
18 should not use the multi-tool. However,
persons over the age of 16 may use the device
for training purposes only under the
supervision of a qualified trainer.
Use multi-tools with the utmost caution and
vigilance.
Only operate the multi-tool if you are physically
fit. Perform all work calmly and cautiously. You
are responsible for other people.
Never use the multi-tool after consuming
alcohol or medication, or if you feel tired or ill.
National regulations may limit the use of the
device.
Individual protection device
The clothes you wear must be functional and
suitable, that is to say, they must be close to
the body, without impeding your movements.
Do not wear jewelry or clothing that could get
tangled in thickets or small shrubs.
To avoid injury to your head, eyes, hands or
feet and to protect your hearing when using the
THERMAL BRUSH CUTTER 4 IN 1
WARNING:
multi-tool, wear the following protective
equipment and clothing.
Always wear a helmet where there is a risk of
falling objects. The protective helmet should be
checked at regular intervals for possible
damage and should be replaced no later than
every 5 years. Use only approved protective
helmets.
The helmet visor (or alternatively the goggles)
protects the face from debris and flying stones.
When using the multi-tool, always wear
protective goggles or a visor to protect your
eyes from injury.
Wear adequate noise protection equipment to
prevent hearing loss (ear muffs, earplugs,
etc.).
Coveralls protect against flying stones and
debris.
It is strongly recommended to wear a coverall.
Special thick leather gloves are part of the
prescribed equipment and must be worn when
using the multi-tool.
Also always wear safety shoes with a non-slip
sole. They will protect you from possible
injuries and ensure good stability.
Starting the multi-tool
Make sure no children or adults are nearby
and watch out for animals in the work area.
Make sure that the fixing part is in place, that
the control lever can be operated easily and
that the locking lever operates correctly.
It is forbidden to move the fixing piece during
idling. If in doubt, check the setting with your
dealer. Check that the handles are clean and
dry and that the on/off switch works properly.
Start the multi-tool only as instructed.
Do not start the engine by any other method!
80
Werbung
