Austroflamm Perry Betriebsanleitung Seite 52

16 | Electrical connection diagram
16 Electrical connection diagram
16.1 Electrical connection
NOTICE
Repairs to your pellet stove must only be carried out by authorised Austroflamm engineers.
Fig. 75: Fuse holder with T2.5A glass tube
fuses
16.2 Model with permanently running screw motor
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
(OPT)
52
Your pellet stove is designed for connection to a 230 V / 50
Hz mains. The connection cable is included.
The mains socket connection is located on the rear of the
appliance and is protected with a T2.5 A glass tube fuse.
The power consumption of your pellet stove is visible on
the nameplate.
Phase converter
RPM / HAL-IC
Earth - induced-draft fan
Earth - DC control side
Room temperature sensor
Firebox temperature sensor
Differential pressure measurement P1, P2
Ceramic ignition
Induced-draught fan
Air distribution module (optional)
Control - permanently
running screw motor
Safety temperature limiter
Hopper lid switch
Grate motor, power release for
auger motor
Grate motor
External thermostat
EN Operating manual Perry