Austroflamm Perry Betriebsanleitung Seite 37

Operating manual Perry
12.5 Setting / editing new heating times
1
7
6
Fig. 39: Creating heating times
1 Back without
saving
3 Save
5 End of heating
time
7 Weekdays
2 3
5 4
2 Delete heating
time
4 Target temper-
ature
6 Start of heating
time
EN
SETTING:
1) Set the weekdays, the start and end of the heating
time and the room temperature accordingly.
2) Save the heating time by pressing the "Save" symbol.
ð You will then be automatically taken back to the
heating times list.
You can delete an existing heating time as follows:
3) Highlight the heating time and press the "Delete heat-
ing time" symbol.
ð The timer function may only be enabled after the
desired heating time has been set.
When setting heating times, please note the following: The
timing must be in the future.
EDITING:
4) Disable timer.
5) Set new heating times
6) Enable timer.
12 | Operation
37