Disassembly And Disposal; Taking The Warewasher Out Of Operation For Long Production Stops; Disassembly; Disposal - Miele PTD 901 Betriebsanleitung

| |
English 9

Disassembly and disposal

9 Disassembly and disposal
9.1

Taking the warewasher out of operation for long production stops

If the warewasher is taken out of operation for long periods (company holidays, seasonal operation), carry out the following steps:
Ø
Have the dosing devices rinsed with water by a service technician and allow them to dry. If necessary, observe the dosing device
information provided by third-party manufacturers.
Ø
Use the self-cleaning programme to empty the warewasher.
Ø
Clean the warewasher.
Ø
Open the hood.
Ø
Switch off the local water supply.
Ø
Disconnect the warewasher from the electrical mains supply.
Ø
Empty the water treatment unit (e.g. partial demineralisation cartridges).
If the warewasher is in a place that is not frost-free, the boiler and, if necessary, the water circuits of the heat pump must also be emp-
tied.
Ø
Instruct an authorised service technician to secure the warewasher against frost.
9.2

Disassembly

Ø
Remove any wash items and baskets from the warewasher.
Ø
Empty the warewasher completely.
Ø
Disconnect the warewasher from the electrical mains supply.
Ø
Disconnect the warewasher from the local water supply.
Ø
Disassemble the table system.
Ø
Disassemble the exhaust air system, if present.
9.3

Disposal

Incorrect or negligent disposal can cause considerable environmental pollution and/or damage.
Ø
For hazardous substances, please observe the disposal regulations on the safety data sheets.
Ø
Disposal according to national regulations.
82
| |
12020321/01; 2023-07 Operating instructions