|
|
English
5
Commissioning
Requirements for on-site installation
Inlet water connection
Location
Construction
Inlet water temperature
Water quality
Water hardness
Water flow pressure
Max. inlet pressure
(back pressure)
Flow rate
Waste water connection
Location
Dimensions
62
approx. 500 mm above finished floor; to the right of the machine
Isolation valve with G ¾" external thread
PTD 901,
PTD901 Lift
PTD 901 ECO,
PTD 901 Lift ECO
Microbiologically, fresh water must be of drinking water quality
PTD 901,
PTD901 Lift
PTD 901 ECO,
PTD 901 Lift ECO
PTD 901,
PTD901 Lift
PTD 901 ECO,
PTD 901 Lift ECO
1000 kPa (10,0 bar)
min. 4 l/min
approx. 650 mm above finished floor; left or right of the machine
Ø 40 mm or 50 mm with trap
|
12020321/01; 2023-07
max. 60°C
max. 20°C
Machines without integrated
softener
≤ 3 °dH (3.8 °e / 5.34 °TH / 0.54
mmol/l)
Recommended, to prevent ware-
washer from scaling up.
≤ 3 °dH (3.8 °e / 5.34 °TH / 0.54
mmol/l)
Connection of osmosis water is not permitted due to the copper
pipes in the waste air heat exchanger
100 kPa (1,0 bar)
150 kPa (1,5 bar)
|
Machines with integrated softener
≤ 31 °dH (37.6 °e /
53.4 °TH / 5.35 mmol/l)
≤ 20 °dH (25.1 °e /
35.6 °TH / 3.58 mmol/l)
Operating instructions