Disassembly And Disposal; Taking The Warewasher Out Of Operation For Long Production Stops; Disassembly; Disposal - Miele PTD 901 Originalbetriebsanleitung

| |
English 9

Disassembly and disposal

9 Disassembly and disposal
9.1

Taking the warewasher out of operation for long production stops

If the warewasher is taken out of operation for long periods (company holidays, seasonal operation), carry out the following steps:
Ø
Use the self-cleaning programme to empty the warewasher.
Ø
Clean the warewasher.
Ø
Open the hood.
Ø
Close the on-site water supply.
Ø
Disconnect the warewasher from the electrical mains supply.
Ø
Rinse the dosing device with water and allow to dry. If necessary, observe the dosing device information from third-party manufac-
turers.
Ø
Empty the water treatment (e.g. partial demineralisation cartridges).
If the warewasher is in a place that is not frost-free, the boiler must also be emptied.
Ø
Instruct an authorised service technician to make the warewasher frost-free.
Warning
Risk of scalding from hot water
When emptying the boiler, the drain pump and the sump pots, please be aware that hot water may cause severe burns.
Ø
Let the warewasher cool down before carrying out assembly work.
Ø
Wear protective clothing, protective gloves and protective goggles.
9.2

Disassembly

Ø
Remove any wash items and baskets from the warewasher.
Ø
Empty the warewasher completely.
Ø
Disconnect the warewasher from the on-site electrical connection.
Ø
Disconnect the warewasher from the on-site water supply.
Ø
Disconnect the warewasher from the on-site water disposal.
Ø
Disassemble the table system.
Ø
Disassemble the exhaust air system, if present.
9.3

Disposal

Incorrect or negligent disposal can cause considerable environmental pollution and/or damage.
Ø
For hazardous substances, please observe the disposal regulations listed in the safety data sheets.
Ø
Disposal according to national regulations.
98
Ø
Use the self-cleaning programme to empty the warewasher.
Ø
Remove the front cover.
Ø
Guide the drain hose (3) out of the machine frame.
Ø
Loosen the hose clamp (1) on the drain hose (3).
Ø
Remove the plug (2).
Ø
Fully drain the water from the boiler.
Ø
Replace the plug (2) and secure with hose clamp (1).
3 2 1
|
12020302; 2021-09
|
Operating instructions PTD 901