Trouble Shooting Guide - Gastroback DESIGN FLEISCHWOLF ADVANCED Bedienungsanleitung

TROUBLE SHOOTING GUIDE

Always clear blockage according to the following instructions. For the case that you are
unsuccessful take the appliance to an authorised specialist reparation shop.
Possible problem
The mince is not fine enough.
There are still ingredients in the feed chute
but no mince is coming out of the mincer.
The motor stops running while operating.
After cleaning the motor does start again
when turning the appliance ON.
The mincer blocks up permanently while ope-
rating.
The worm housing moves while operating.
The mince leaks out at the side of the clo-
sing ring.
40
Easy solution
Use a smaller grinding disc and/or mince the ingredients more then
once.
The mincer is blocked. Turn the appliance off immediately and ope-
rate according to the instructions ›Clear a blocking‹.
The overload protection might got activated. Turn the appliance off
mmediately and operate according to the instructions ›Clear a blo-
cking‹.
• Is the power cord plugged in?
• The motor might be blocked with some hard substance (for exa-
mple a bone). Turn the appliance off immediately and pull the plug.
• Disassemble and clean the appliance. Operate according to the
instructions ›Care and cleaning‹.
• If the problem is not solved after the cleaning, take the appli-
ance for technical maintenance and repair to an authorised service
center.
• To ensure that the mincer does not seize, never operate it
under excessive pressure. Operate in a slow and constant pace. Do
not try to rush the procedure by pushing down the meat with force.
• For mincing hard ingredients really fine start with the grinding
disc with the bigger holes. Mincing the second time use the finer grin-
ding disc.
The closing ring loosened. Turn the appliance off immediately. Assem-
ble the worm housing according to the instructions ›Assemble for
mincing‹.
The closing ring is not screwed on tight enough. Turn the appliance
off immediately and then pull the plug. Tighten the closing ring but
do not overwind the winding. If the problem still occurs disassemble
and clean the appliance.