Gastroback DESIGN FLEISCHWOLF ADVANCED Bedienungsanleitung Seite 30

if it was excessively loaded. The appliance is likely to be damaged if
the appliance or parts of the appliance show cracks, exorbitant wearing
down, alterations or leaks. It is also likely to be damaged if the drive
wheel of the motor housing moves slowly. Take the appliance for techni-
cal maintenance and repair to an authorised service center.
• Never use force assembling or disassembling the appliance. The single
parts should be put together easily. Only operate the mincer after it has
been carefully assembled following the instructions ›Assembling the appli-
ance‹.
• Never use the crossed-blade knife and grinding disc in combination with
the sausage filling attachment and adaptor disc. Only use either the
crossed-blade knife with the grinding disc or the attachment.
• Always turn the appliance off (by turning the control switch to STANDBY),
wait for the motor to stop moving before pulling the plug or disassembling
the mincer.
• For the case that the worm housing or the closing ring loosen while ope-
rating turn off the appliance immediately (by turning the control switch to
STANDBY) and pull the plug. Operate according to the instructions ›Trou-
ble shooting‹ before turning the appliance on again.
• The mincer must only be used to process meat and vegetables. Do not
mince hard parts such as bones. Do not mince hard-fibre foods such as
ginger, etc. The mincer cannot mince hard or stingily ingredients (for exa-
mple: bones, nuts, ginger). If you use hard ingredients like onions or car-
rots, you have to steam them before adding them to the meat otherwise
they can block the motor. If the motor or if the worm is blocked turn off the
mincer (by turning the control switch to STANDBY) and wait for approx.
6 seconds to be certain that the motor is no longer running. Work accor-
ding to the instructions ›Trouble shooting‹ before continuing operation.
ATTENTION: Do not let the motor run permanently for longer then 15
minutes on maximum power to avoid overheating. After 15 minutes turn
off the appliance and let the motor cool down for several minutes before
continuing operation. With normal load the permanent running time is 30
minutes.
30