Set-Up, Connection And Initial Start-Up En; Choosing A Suitable Location; Having The Outlet Hose Connected . En - hanseatic HGTI6082C147735TS Gebrauchsanleitung

Set-up, connection and initial start-up

Choosing a suitable location

CAUTION!
Risk of injury!
The appliance is heavy and bulky. Im-
proper handling of the appliance may
lead to injuries.
Seek the help of another person dur-
■
ing transport, installation and assem-
bly.
Only lift the appliance as shown on
■
the packaging.
Remove all obstacles on the transport
■
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the floor.
The planned location must fulfil the following
prerequisites:
– The location must be a dry and frost-safe
room with a firm ground.
– The dishwasher must be positioned be-
neath a full work surface which is joined
together with the cupboards adjacent to the
dishwasher.
– In order to install the connection pipes, the
dishwasher must be positioned near to a
washing/dishwashing basin or the floor
drain.
– The measurements of the recess must at
least correspond to the details in the dia-
gram.
• Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
Set-up, connection and initial start-up
90°
820 mm
580 mm
Recess dimensions
Having the outlet hose
connected
NOTICE
Risk due to malfunction!
Failing to connect the appliance cor-
rectly may cause malfunctions during
operation.
Make sure that the waste water can
■
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
Ensure that there are no kinks or dam-
■
age to the outlet hose.
Make sure that the end of the hose is
■
not submerged in the pumped water.
Do not extend the outlet hose or re-
■
place with another drainage pipe.
The outlet hose must only be con-
■
nected by qualified personnel.
Page EN-29
90°
80 mm
100 mm
Inlet/outlet area and
electrical connec-
tion.
600 mm