Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BNI PNT-508-105-Z067 / BNI PNT-508-105-Z077 / BNI PNT-502-102-Z078
Network interface
3
Display
The display consists of two LEDs, two buttons and an LCD
display. A backlight is built in, so that readability is
guaranteed even in low ambient light. The backlight is also
activated when the menu is started.
It is possible to display the station name. In the delivery
state,
is displayed, which means that no name has
nO name
yet been assigned to the module.
The IP settings are represented by the following items and
reflect the current configuration of the module.
–
IP address (IP)
–
Subnet mask (SN)
–
Gateway address (GW)
Each address consists of 4 octets.
In addition, the display shows information about the name
of the device, the hardware and software version and the
MAC ID.
Resetting the address settings to factory defaults is also
possible via the display.
3.1
Control and display
1
Display
2
Arrow button
3
Octet cursor
Fig. 3-1:
Explanation of the control panel
Arrow button: This button is used to move through the
menu items and is a momentary pushbutton. The display
shows the default screen after 10 seconds of inactivity.
Octet cursor: The default position of the octet cursor is
position 0, this represents the least significant octet.
Address type cursor: The default position of the address
type cursor is the IP position. Set button: This button is
used to start editing mode and save or to confirm a
change in the configuration.
LEDs: The two LEDs can be actuated via the process
data of the module. For this purpose, the d
module must be selected.
www.balluff.com
4
Address type cursor
5
Set button
6
LEDs
l
iSplay
edS
3.2
Display information
Cursor to select the address type
IP
SN
Subnet
GW
Gateway
3
Fig. 3-2:
Explanation of display
3.3
Design and symbols
In the following flowcharts, a number of symbols are used
to describe the display functionality:
Symbol
Meaning
Current state
Switch
Condition: Short press of Set button
Condition: Long press of Set button
(≥ 3 s)
Condition: Short press of arrow button
Tab. 3-1:
Explanation of symbols
3.4
Startup
Module name
Hardware and firmware
version
2
1
0
Cursor to select the octet
english
23
Werbung
Inhaltsverzeichnis
