Balluff BNI PNT-502-102-Z078 Konfigurationsanleitung Seite 88

BNI PNT-508-105-Z067 / BNI PNT-508-105-Z077 / BNI PNT-502-102-Z078
Network interface
4
WebUI/web interface (continued)
Application recommendation for a Port X in the context of
the other designation variables (see Fig. 4-32):
– – name of the device that shows what
d a
evice liaS
function the sensor executes (e.g. rear left end switch,
temperature at boiler floor, etc.)
– m p 4 – selection of the actuation (e.g.
OduS in
Deactivated, IO-Link [Manual], IO-Link [Autostart],
Digital in or Digital out. Depending on the selection,
further dialog fields open, which require an input (e.g.
when the IO-Link [Manual] option is selected).
– c t – if the IO-Link [Manual] or IO-Link
ycle ime
[Autostart] options are selected for point Modus Pin 4,
the desired communication cycle can be set by
selecting the corresponding value from the dropdown
list.
– 2 (claSS_a) – selection of the options
m p
OduS in
d or d
igital in igital Out
Fig. 4-32: m p 4 selection options dialog and Port 2: Configura-
OduS in
tion dialog of the iO-l
The port configuration is not permanently stored.
After a reset, reboot or a deenergized phase, the
settings are lost.
The following changes are only possible if the port
is disabled beforehand:
– The port is configured as an IO-Link Port and is
to be changed to a different IO-Link mode.
– The validation information iO-l
be changed.
38 english
.
[m ] option
ink anual
[m ] is to
ink anual