Balluff BNI PNT-502-102-Z078 Konfigurationsanleitung Seite 61

BNI PNT-508-105-Z067 / BNI PNT-508-105-Z077 / BNI PNT-502-102-Z078
Network interface
2
System integration (continued)
Hardware configuration
The remaining modules can, if necessary, be pulled into
the configuration table from the hardware catalog using
drag & drop and must be configured in accordance with
the configuration of the Headslot.
Default setting: all ports are standard inputs/
outputs (SIO).
Addressing modules
After double-clicking on the modules, the addressing can
be changed in the a
ddreSSeS
Configuring an IO-Link module
If a port is to be configured as an IO-Link port, Standard
I/O must be deleted at Standard configuration and
replaced with an IO-Link module.
Slots 1 to 8 are reserved for the IO-Link ports.
► In accordance with the process data length of the
IO-Link device, select a matching IO-Link module in the
catalog and drag it to the corresponding slot using
drag & drop.
The process data length required by the device can be
found in the manual for the IO-Link device.
Fig. 2-11: Hardware configuration
www.balluff.com
window.
Configuring the standard input/output
If one of the possible port pins (e.g. Pin 4) is to be
configured with a standard function (input, output), the
Standard I/O placeholder module must be used for the
corresponding slot.
To address the inputs and outputs, the corresponding
Inputs Pin 2/Port 4...7 (Inputs Pin 4/Port 0...3) and
Outputs Pin 2/Port 4...7 (Outputs Pin 4/Port 0...3)
modules must be pulled from the catalog into the
parameterization.
To use the IO-Link SIO functionality, the IO-Link input with
SIO mode module is required.
With the remaining modules, different functions are
mapped in the respective process data areas (see
Fig. 2-11).
english 11