Energy Saving And Battery - Verefa V60M Pro Gebrauchsanleitung

Energy saving and battery

Holiday energy saving mode
- On the charging base, press and hold the recharge button for 10 seconds until you hear the prompt
tone. At this time, the holiday energy saving mode will be activated.
- In the holiday energy-saving mode, network, remote control and scheduling will be turned off, and
the robot will enter the low-power mode to save energy.
- Only when the robot is removed from the charging base or any button is pressed can the function be
ended.
- And the auto-empty charging base also needs to be unplugged to power off for ending the holiday
energy saving mode on the auto-empty charging base.
Remove the battery (for disposal)
- This is applicable when discarding this product and is not a daily operation instruction.
- The chemical substances contained in the built-in lithium-ion battery of this product may pollute
the environment. Please remove it before scrapping and hand it over to a professional battery
recycling bin for centralized treatment.
1. Let the robot run to a low power state that cannot be cleaned without touching the charging base.
2. Press and hold the power button for 3 seconds to turn off the robot.
3. Remove the screws of the battery compartment of the robot with a screwdriver and take out the
cover of the battery compartment.
4. Press the snap down to pull out the connector plug and take out the battery.
- When removing the battery, make sure that the power is exhausted as far as possible and operate
safely with power cut off.
- Please remove the whole battery pack together. Do not damage the shell of the battery pack to avoid
short circuit or leakage of dangerous substances.
- If the battery has exudate and is accidentally touched, please wash it with plenty of water and get
medical attention in time.
034