Network Functions - Verefa V60M Pro Gebrauchsanleitung

- When finishing mopping the floor, charging or not using, please remove the mopping module and
clean the mop pad in time, and pour out the water in the water tank to avoid odor or mildew.
Note:
- Please use the mopping function when someone is looking after.
- Don't allow wet mopping modules staying in a certain area for a long time to avoid excessive
moisture damage to the ground.
- When the mopping module is installed, the obstacle crossing height of the Robot Vacuum will be
reduced. Please be aware of the possibility of stucking
- The mopping function is only applicable to the clean floor without stubborn stains or liquid. If there
are coffee stains, ink stains and other colored stains on the floor, do not use the mopping function
to avoid soiling the floor.
- Mopping works best on smooth, hard surfaces, but may not work well on uneven tiles, heavily
waxed floors, or rough surfaces. Because it may get stuck, slip, and not be able to mop the floor
smoothly.
- Do not use the mopping function on the carpet.
- For better mopping effect, it is recommended to vaccum the floor 3 times with the Robot Vacuum
before using the mopping function.
◉
Water amount adjustment
- In order to ensure the best mopping effect, users can choose different water output levels for
mopping according to their needs.
- Higher water amount means less mop time at one time.
- Please pay attention to whether you need to replenish water to achieve the best mopping effect.

4.3 Network functions

◉
Reset Wi-Fi
- If your mobile phone cannot connect to the robot (such as
configuration or password change of your router), try to
reset the Wi-Fi and reconnect to the network.
- Press and hold both buttons (
and Recharge button) for 3 seconds until you hear the
voice prompt. The three indicators flash slowly, indicating
that the robot is ready for pairing.
- For detailed Wi-Fi setup instructions, refer to "Installation >
Connect to mobile client" in this manual.
Spot Cleaning button
019