Verefa V60M Pro Gebrauchsanleitung Seite 14

2) Install side brush
3) Place the charging base, connect the power supply and charge the robot
1
Connect the power cable and organize the power
cables with the cable ties.
Note :
- Power cable on your floor may entangle the
robot, resulting in power failure or jamming
of the robot.
2 Place the charging base and power it on.
- Place the charging base in an easy-to-access
position for the robot.
Note :
- Ensure that no objects are placed within 1.5m
in front of the charging base and 0.5m from
both sides.
- Do not cover the signal transmitting area of the
charging base with any object.
- Avoid direct sunlight, which will affect the
recharge effect.
- Place the charging base on a level, non-slip, hard surface and against a wall.
Note :
- To avoid recharging failure caused by position change, do not put the charging base on a carpet or
blanket.
- Always connect the charging base to the power supply. Ensure that it is located in a place with
continuous Wi-Fi network and good network performance.
Note :
- Always keep the charging base plugged in, otherwise the robot will not return automatically.
- To return to the charging base smoothly after cleaning, it is recommended to start cleaning from
the charging base. Do not move the charging base during cleaning.
Click
Good Wi-Fi coverage
>0.5m
012
>0.5m
>1.5m
Store the
power cable
in its storage
slot.