Troubleshooting - Verefa V60M Pro Gebrauchsanleitung

5.2 Troubleshooting

If an error occurs while the robot is working, the indicator light of the robot or the auto-empty
charging base will light up in red in different states with corresponding prompt sound. Please solve it
by the following table.
Indicator light
Error 1: Front bumper stuck. Please
clean and retry.
Error 2: Side brush stuck. Please
clean and retry.
Error 3: Roller brush stuck. Please
clean and retry.
Error 4: Wheel stuck. Please clean
and retry.
Robot -
Slowly
Error 5: Optical path sensor dirty.
Flashing Red
Please clean and retry.
Error 6: Filter blocked or wet.
Please clean, dry and retry.
Error 7: Wheel suspended. Please
move it to near its original position
and retry.
Error 9: Strong magnetic field
detected. Please relocate it to start.
Robot -
Solid Red
Error 11: Low Battery. The system
is about to shut down. Please
charge it.
Voice prompt
- The front bumper is stuck. Please tap repeatedly to
remove any dirt. After confirmation, please relocate
it to start.
- The side brush may be entangled with trapped dirt.
Please clean and retry.
- The roller brush may be entangled with trapped
dirt. Please clean the roller brush and retry.
- The wheel may be entangled with trapped dirt.
Please clean the wheel and retry.
- The optical path sensor may be stuck with dust.
Please wipe it with a dry cloth and retry.
- The filter may be blocked or wet. Please clean it. If
it is not dry, please dry it for at least 24 hours. If it
cannot be solved, please replace the filter.
- The robot may be picked up or suspended, please
move it to a new position close to the original
position and retry.
- The robot is suspended in the air or the cliff sensor
may be stuck with dirt or blocked. Please wipe the
cliff sensor with a dry cloth and then move it to a
nearby place to start.
- When starting, the robot is too close to a magnetic
boundary strip or strong magnetic field. Please put
the robot on a new location to start.
- The battery power is low (less than 5%) and it is not
on the charging base. Please charge the robot at
the charging base.
028
Solution