Communication; Scale To Device Port Connections; Usb (Type C) Port; Ups Worldship To The Pc Connection - OHAUS Courier 5000 Bedienungsanleitung

Courier 5000

5. COMMUNICATION

The Courier 5000 scale can be set up to be compatible with UPS WorldShip shipping software.
5.1

Scale to Device Port Connections

The Courier 5000 scale has a USB type C port.

5.1.1 USB (Type C) Port

You must select the protocol to be compatible with UPS WorldShip shipping software. UPS WorldShip provides
access only to COM ports 1-4 and assign the USB COM port through the Windows Device Manager.
Long press the Menu button until
1.
Release the Menu button, and
2.
Short press the No button several times until
3.
Press the Yes button and
4.
5. Short press the No button once, and ASSIG appears on the display.
Short press the Yes button to enter the sub menu.
6.
Short press the No button several times until
7.
8. Short press the Yes button to confirm.
9. Redo step 1 and 2, then short press the No button several times until
can set the Baud Rate(
1 bit
bit( ) in the USB(
10. Press Menu button to exit.
5.2

UPS WorldShip to the PC Connection

Steps
1. Start the UPS WorldShip software and go to the System Preferences screen.
Click the System Preferences and select the Hardware, a window called System Preferences Editor
2.
appears on the screen.
3. Select the corresponding COM port from the Scale port drop-down list.
NOTE: You can check the exact COM port from the Windows Device Manager without leaving the
WorldShip software.
4. Select the NCI 3835 protocol from the Scale Type drop-down list.
5. Click the Test Scale button. A window for Test Active Scale will appear.
NOTE: As the test goes from start to end, you can see the progress bar changes from Weight Processing to
Weight Processed.
6. Click OK button to close the Test Active Scale window once the weight is successfully processed.
NOTE: The weight on the scale and the weight in UPS WorldShip should be the same. In some cases,
WorldShip may round extra digits from the display weight. If the displayed weight and WorldShip weights are
very different, check that the scale and WorldShip are using the same weighing unit (kg, lb or oz).
7. Click Apply button to save the selections.
8. Click OK button to close the System Preferences Editor window, Courier 5000 is ready for UPS weight
processing.
NOTE: UPS WorldShip software only processes the numeric weight value from the scale -- it does not
autosense the weighing unit (kg, lb or oz) nor does it make a conversion from one weighing unit to another.
Make sure the correct weighing unit is selected on the scale before weighing.
mM.E.N.U
C.A.L
appears on the display if CAL lock is off.
rESEt
appears on the display.
baUd 4800
) to 4800(
U.S.b
) menu.
2
appears on the display.
P.r.N.t
. appears on the display.
UPS
appears on the display.
PArIt
), Parity( ) to 7-Even(
3
4
5
6
U.S.b
appears on the display. you
7-Eue
) and Stop Bit(
8
5
7
6
EN-23
StOP
) to 1