OHAUS Courier 5000 Bedienungsanleitung Seite 15

Courier 5000
Starting the Dynamic Weighing/Display Hold Mode:
1. Long press the button Function Mode until
2. Release the button Function Mode, and
3. Put the load on the platform.
• If the operation type is manual, you must press the Function button to start the averaging process.
• If the operation type is semi-automatic/automatic, the scale performs the averaging process
automatically when the load weight is bigger than the start weight.
NOTE:
• You can set the value of the start weight via this path:
correct range of the start weight value is 5d - capacity value.
• During the averaging period, the countdown timer decreases in one second increments. If the set
average time is 0s, the countdown timer is not displayed.
• The values on the display are averaged and held on the display when the countdown is completed.
4. Read the values on the display if the tilde (dynamic) symbol blinks on the display.
5. Reset the countdown timer:
• If the operation type is manual/semi-automatic, press the Function button to reset the countdown timer
when the countdown is running. The display shows
• If the operation type is automatic, remove the load from the scale. And the average weight will still be
displayed until the duration time is over. Then the display shows
NOTE:
rEADY
• The display must be at zero gross or net value to reset the countdown timer.
Application Settings
The Dynamic Weighing Configurations are defined below (Defaults in Bold).
Item
Dynamic Mode
dyNA
（ ）
Dynamic Operation
tyPE
Type ( )
Start Weight
StArt
( )
Duration Time
dUrAt
( )
Average Time
AuErA
( )
NOTE: The Dynamic mode cannot be disabled if the scale is in the Dynamic mode currently.
rEAdY
Available Settings
OFF On
Off ( ) / on ( )
mMAN
Manual ( )/
semMI
Semi-auto ( )/
AUtO
Auto ( )
5d - Capacity Weight
1 - 10 s
0 - 30 s
dyNa
appears on the display.
appears on the display.
mMENU
rEAdY
and start to re-count.
Comments
Count down:
There is a countdown time.
Manual:
The averaging process is started and reset manually.
Semi-auto:
The averaging process is started automatically and reset
manually. Resetting is initiated by pressing the FUNCTION key.
Auto:
The averaging process is started and reset automatically.
Dynamic weighing will start when the load is bigger than the start
weight (for Semi-auto and Auto mode).
Duration time of weighing result after the load is removed (only
for AUTO type).
Time in Seconds.
If the average time is 0, the first stable weight (more than or
equal to 5d) will be the result.
mM.O.d.e dyNa
> > >
rEAdY
, and start to re-count.
EN-11
StArt.
And the