Weight Alert - OHAUS Courier 5000 Bedienungsanleitung

EN-12

3.5.4 Weight Alert

This application is used to judge if the weight of the item is within the target limit. There are 2 limit values for
setting, the limit 1 is normally on as default.
Setting the Limit Values
Long press the Mode button until
1.
2. Release the Mode button, the
3. Press Yes button to remove the stored alert limit value, and
4. Press Yes button,
5. Set the limit value 1:
a) Use the buttons NO and Back to set a number for the first digit.
Short press the Yes button to confirm the number and move to the next digit.
b)
c) Repeat the steps a) and b) to set numbers for all the digits.
d) Press Yes button to confirm the value. If the value is not in the correct range, the
display, then the display shows
value is in the correct range, the
LimM.2
NOTE: If the
the weighing status directly.
6. Redo steps 4 and 5 to set the limit value 2.
If the limit value 2 is not in the correct range,
Please redo step 5.
If the limit value 2 is in the correct range, the scale goes into the weighing status.
NOTE:
1. You can check the limit values by short pressing the Function key.
2. You can set either or both limit values. When limit value 2 is on and limit value 1 is not equal to limit value
2. If the object weight value is between the two limit values, the segment text and the backlight blink
together. If the object weight value is larger than the maximum limit value, the segment text blinks.
If the weight value of the load is larger than both the limit values, the segment text blinks.
3. The maximum limit value is not larger than the capacity value (Refer to Table 8-1 for the capacity value of
all models).
ALert
appears on the display.
CL.ALe
appears on the display.
000000
flashes on the display with the current unit.
LimM.1
LimM.2
is set to off, the
LimM.1
. You must repeat the steps 4 and 5 to set the value. If the
appears on the display.
LimM.2
will not appear on the display and the scale goes into
NO
appears on the display, then the display shows
appears on the display.
NO
appears on the
Courier 5000
LimM.1.