Safety Devices; Removing The Appliance From Its Packing Materials - Comet KL 1680 GOLD PLUS Bedienungs- Und Wartungsanleitung

21 Opening for detergent
22 Water brush
23 High pressure hose
27 Warning notice

2.2 Safety Devices

This water cleaner is provided with the following safety devices:
a) Thermal protector
It's a device that stops the water cleaner operation in case of motor overheating.
In this case, proceed as follows:
• switch the main switch (2) to position "0" and remove the plug from the power outlet;
• press the lever (26) on the cleaner gun to eliminate any remaining pressure;
• wait 10 to 15 minutes until the water cleaner cools down;
• check that the instructions in the "Checks and Connection to the Mains Electricity Supply" section
have been followed, particularly regarding any extension cord used;
• replace the electric plug in the power outlet and repeat the start-up procedure described in the
"Operation" section.
WARNING
• If this safety device cuts in repeatedly, do not use the water cleaner until it has been checked by a Skilled
Technician.
b) Pressure limit/adjustment valve
When this valve has been correctly set, the pumped fluid is able to return to the pump's suction
unit, thus preventing the creation of dangerous levels of pressure when the cleaner gun is stopped
or should pressure be set that is above allowed levels.
c) Safety stop on cleaner gun lever
This is a safety catch (25) which, when pressed, lets you block the lever (26) on the cleaner gun
(14) to prevent the possibility of it being started by accident (see also Fig. 4, pos. S)
2.3 I u
ntEndEd sE
WARNING
• This water cleaner is to be used exclusively for:
- cleaning vehicles, machinery, buildings, tools etc with cold water, possibly with the addition of detergents
as per the Manufacturer's instructions;
- distributing detergents as per the Manufacturer's instructions;
- removing lime scale and unblocking pipe work using the appropriate tools as per the Manufacturer's
instructions;
- water sanding objects using the appropriate tools as per the Manufacturer's instructions;
• The water cleaner must not be used to wash people, animals, energized electrical appliances, delicate
objects or the high pressure cleaner itself.
• The high pressure cleaner is not suitable for use in certain situations such as in corrosive or explosive
atmospheres.
• Contact the Manufacturer's service centre before use on board vehicles, ships or airplanes, as there may be
additional instructions for use.
Any other use is considered improper.
The Manufacturer is not liable for any damage caused by improper or incorrect use.

3 REMOVING THE APPLIANCE FROM ITS PACKING MATERIALS

WARNING
• Protective gloves and glasses must be worn when removing the appliance from the packing materials to
24 Quick fit connector for high-pressure hose
25 Safety catch on water gun lever
26 Water gun lever
EN
21