Introduction | Intended Use; Exception: Pegasys Pin Code; Exploded View Of Surface-Mounted Installation; Instructions For Outdoor Installation - Simons Voss Technologies PegaSys 2.1 Kurzanleitung

Electronic door fitting PegaSys 2.1 and 4.1 Surface-
mounted
NOTE
Intended use
PegaSys-products are designed exclusively for open-
ing and closing doors and similar objects.
Do not use PegaSys products for any other pur-

poses.
Malfunctions due to poor contact or different dis-
charge
Contact surfaces that are too small/contaminated or
different discharged batteries can lead to malfunc-
tions.
1. Only use batteries that are approved by
SimonsVoss.
2. Do not touch the contacts of the new batteries
with your hands.
3. Use clean and grease-free gloves.
4. Always replace all batteries at the same time.
Qualifications required
The installation and commissioning requires special-
ized knowledge.
Only trained personnel may install and commission

the product.
Modifications or further technical developments can-
not be excluded and may be implemented without no-
tice.
The German language version is the original instruction
manual. Other languages (drafting in the contract lan-
guage) are translations of the original instructions.
Read and follow all installation, installation, and com-
missioning instructions. Pass these instructions and
any maintenance instructions to the user.
2. Introduction | Intended
use
Electronic door fittings in the PegaSys range are used
to provide access control for individual doors. You will
only be able to unlock a door with an electronic door
fitting if you identify yourself as an authorised person
with a valid credential.

2.1. Exception: PegaSys PIN Code

You can only operate this version of an electronic door
fitting using codes that you enter into the built-in
keypad. You can programme the door fitting with
codes and assign a specific function to each code.
EN
You can enter a specific code to unlock the door when
it is in service, for example.
Please refer to a separate quick guide for more details
on the PegaSys PIN code.
3. Exploded view of sur-
face-mounted installa-
tion
1
4. Instructions for outdoor
installation
When installing outdoors, use the supplied rubber seal
to protect the PegaSys housing against water ingress:
1. Align the outer edge of the seal with the door edge
and position the punch-outs in the centre.
2. Fix the seal to the door with adhesive.
3. Install the PegaSys door fitting.
General instructions on outdoor installation
IMPORTANT
Battery compartment not waterproof
The battery compartment itself is not protected
against water ingress.
1. Install the battery compartment in the protected
inner area. Use the screw-on battery compartment
(option .WPSC) or the snap-in battery compart-
ment (option .WPSN) for this.
2. Route the battery cable from the protected inner
area through the door and to the electronic fitting in
the outer area.
5. Preparing the cylinder for
PegaSys 2.1
2
Check the cylinder length.

The profile cylinder must protrude 27–31 mm from the
outer fitting (on the left in the diagram) and 8–12 mm
from the inner fitting (on the right in the diagram).

2. Introduction | Intended use

21 / 40