Trouble Shooting - Parkside PHD 150 A1 Originalbetriebsanleitung

GB
IE

Trouble shooting

Problem
ON / OFF switch (10) is
turned off
Washer is not Damaged power supply
operating cable (6)
Mains fault
Air trapped in the pressure
Washer does
washer
not generate
any pressure
Drop in the water mains
pressure
Severe pressu- High-pressure nozzle (17)
re fluctuations is dirty
12
Possible cause Remedy
Check ON / OFF switch (10)
Check power supply cable (6) for
damage. If necessary have the power
supply cable (6) replaced by a quali-
fied electrician.
Check the electrical system for confor-
mity with the data on the rating plate.
Turn on the washer with high-pressu-
re hose until bubble-free water flows
out of the high-pressure connection.
Check the water mains.
Rinse the high-pressure nozzle (17)
with water. If necessary clean the
nozzle hole with a needle.