Herunterladen Inhalt Inhalt Diese Seite drucken

Interrupting Operation; Ending Operation; Using Detergents; Cleaning And Maintenance - Parkside PHD 150 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PHD 150 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Please repeat process a) to c) a few times
until there is no more air in the device.
B
Lock / unlock the switch-on lever
of the gun (1) by depressing the
locking button (22).
Lock the switch-on lever to pre-
vent the pressure washer from
being inadvertently / acciden-
tally started.
Locked
Open

Interrupting operation

Release the lever of the gun (1).
During prolonged work intervals turn
off the washer by its ON / OFF switch
(10).

Ending operation

After having worked with a detergent
rinse the washer with clear water.
Release the lever of the gun (1).
Turn off the pressure by its ON / OFF
switch (10).
Turn off the water tap.
Disconnect the pressure washer from
the water mains.
Pull the lever of the gun (1) to vent the
pressure existing within the system.
Disconnect the mains plug.

Using detergents

The washer was designed for operation
with a neutral detergent based on a bio-
logically decomposable anionic tenside.
Other detergents or chemical substances
could impair the safety of the washer and
damage it.
To add cleaning agent to the jet, you
must first fill the cleaning agent tank
(15).
Operate the jet tube with flat spray
nozzle (18) in low-pressure mode to
automatically add cleaning agent to
the water.
The rotating brush (19) is always
in low-pressure mode and cleaning
agent will thus always be added to the
water.
To operate the rotating brush (19)
without any cleaning agent, remove
the cleaning agent tank (15).
To remove the cleaning agent tank
(15), hold it on the side and push it
upwards. You can now pull the clean-
ing agent tank out of the bottom and
side guides on the pressure washer.
Mind to first remove the induction
hose and the cap from the opening of
the cleaning agent tank (13) as they
will remain on the pressure washer.
To reinstall the cleaning agent tank,
trace back the above steps.
Cleaning and
Maintenance
Pull out the power plug before every
maintenance operation. There is a
risk of electrocution or of injury from
moving parts.

Cleaning

Never direct the water jet against
the washer, nor clean the washer
under flowing water. This could
give rise to the danger of electric
shock and damage the washer! .
Always keep the washer clean. Do not
use any detergents or solvents.
GB
IE
9

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis