Transport; Storage; Possible Faults - ATIKA BWS 700 N-2 Originalbetriebsanleitung

Transport

Remove mains plug before each transport.
Before each transport:

1. Push the tilt table towards the saw blade.

The safety flap (2A) must be closed properly.
2. Turn down the safety hook until it engages.
Transport: Hold the handle (14), put one foot onto the axle
and tilt the firewood saw towards your body.
In this position, it is easy to move the saw.
Putting down: Put one foot onto the axle and carefully put down
the firewood saw.

Possible faults

Before each fault elimination:
 Switch off device

Wait unitl the saw comes to a stop.
 Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on  Power failure
Jigging does not work
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging
device does not work
Decelaration too slow (time to dead
stop >10 sec.)
Possible cause
 Extension cable defect
 Motor or switch defect
 Safety hook is not released
 Safety flap not pressed down properly.
 Saw blade blunt
 Feed is too great
 Saw blade blunt
 Saw blade is warped
 Saw blade not properly mounted
 Recuperating spring broken or worn out
 Brake defective
 Different causes

Storage

Pull out power plug
Store unused equipment in a dry, locked place out of the reach of

children.
Before a longer period of storage carry out the following to extend the

saw service life and ensure an easy operating:
 thoroughly clean the device
 treat all movable parts with an environmentally friendly oil

Never use any grease!
Remedy
 Check the fuse.
 Check cable, no longer use defect cable
 Have motor or switch checked by an approved
electrician or replaced by original spare parts
 Release the safety hook (3).
 Press down the safety flap properly.
 Replace saw blade or have it sharpend
 Allow motor to cool and proceed working with less
pressure
 Replace saw blade or have it sharpend
 Replace saw blade
 Mount saw blade properly
 Replace the recuperating spring
 Switch checked by an approved electrician or replaced
by original spare part
17