Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Detailed instruction of the connection can be found in
ler terminals
in the appendix section at the end of this manual.
Definition of above type of connections:
3Ph – 3 LN 3
1: one CT connection, 2: two CTs connections, 3: three CTs connections
LN: V measurement between L and N, LL V measurement between phases
1: one V measurement, 3: three V measurements
1Ph: single phase network (L-N or L-L), 3Ph: three phase network
NOTE: L refers to Line, N refers to Neutral
Linear / Circular (Lin./Circ. on the screen)
Linear switching follows the "first in, last out" switching principle.
Circular switching follows the "first in, first out" switching principle.
Both operations are described in the following table.
STATUS
Approved
SECURITY LEVEL
Public
A7. CT connection type illustration and CT wiring on the control-
DOCUMENT ID
9AKK107045A9645
PO WER FACTO R CON TR O LL ER RV T
REV.
LANG.
D
en
© 2022 Hitachi Energy. All rights reserved.
PAGE
47/542
Werbung
