Hose Drainage - Silvercrest SLE 200 B2 Bedienungsanleitung

Hose drainage

In very humid rooms, it often makes more sense to drain off the water directly via a
hose rather than collect it in the water tank 4. You can use the supplied hose d or
the EU garden hose adapter f to set up a permanent drainage outlet.
CAUTION! PROPERTY DAMAGE!
► When draining via the hose, the appliance runs continuously. When draining
via the hose, make sure that it is not kinked and that it runs downwards
along the entire length. Otherwise, the water may flow back into the
appliance and damage it.
► Check the entire connection system regularly for leaks.
♦ Remove the stoppers 9 from the water outlet opening 0.
♦ Connect either the supplied hose d or the EU garden hose adapter f to
the water outlet opening 0 (see figures 4 and 5).
♦ When using the EU garden hose adapter f, screw a garden hose onto
the EU garden hose adapter f (see figure 5).
Fig. 4
CAUTION! PROPERTY DAMAGE!
► Screw the EU garden hose adapter f hand-tight only.
Do not use a wrench as this may damage the EU garden hose adapter f.
NOTE
► Depending on the garden hose system you use, you may need an addition-
al adapter. These are available from specialist stores.
♦ Set up the appliance so that the end of the hose is positioned over a drain.
The open end of the hose must lie below the water outlet opening 0 of the
appliance (i.e. the hose must have a downwards gradient).
SLE 200 B2
Fig. 5
GB │ IE │ 17 ■