F) Log Rate, Set Measuring Interval; G) Data Log. Long-Term Record - VOLTCRAFT VC950 Bedienungsanleitung

f) LOG RATE, Measuring Interval
To use the DMM for long-term recordings, log rate must be defined first. The basic
default setting here is a log rate of 0.5 seconds.
The table shows the available options.
Move to the submenu item "LOG RATE" with the navigation buttons and confirm it with
"ENTER".
Now select an appropriate log rate with the navigation buttons and confirm it with
"ENTER".
Press the button "CANCEL" to leave this function.
g) DATA LOG, Long-Term Record
The digital multimeters can record up to 20,000 measured values for adjustable intervals, depending on type.
To start long-term recording, proceed as follows:
- Switch on the DMM and select the corresponding measuring range with the rotary control (4).
- Move to the submenu item "DATA LOG" with the navigation buttons and confirm it with "ENTER".
- The display shows "START".
- Press "ENTER" to confirm. The recording starts.
- To pause the recording, press "ENTER" again. The display indicates "PAUSE".
- Press "ENTER" again to continue the recording.
- To terminate the recording, change the measuring range or switch off the multimeter.
To look at the recorded values, proceed as follows:
- Move to the submenu item "DATA LOG" with the navigation buttons and confirm it with "ENTER".
- The upper display shows "START". Change to the selection range "VIEW" with the navigation buttons.
- Press "ENTER" to confirm. The last measured value stored will be displayed.
- To verify other measured values that were stored, switch through the memory slots with the navigation buttons.
- Press the button "CANCEL" to leave this function.
To delete all stored measured values, proceed as follows:
Switch off the meter.
Switch on the meter again with the "CANCEL" button pressed.
All stored measured values are now deleted.
LOG RATE
0,5 s 180 s
1 s 240 s
10 s 300 s
30 s 360 s
60 s 480 s
120 s 600 s
51