Switching Off The Device; Transport - Kärcher KM 100/120 R G Originalbetriebsanleitung

CAUTION
Risk of damage due to parcel tape or similar material
Do not sweep parcel tape, pieces of string or similar items (dam-
age to the sweeping mechanics).
Objects or loose obstacles must not be driven over or pushed.
1. Adjust the travel speed to the circumstances for optimum
cleaning results.
2. Sweeping is only permitted with the waste container retracted.
a If the programme selector is set to "Drive", the container flap
is automatically closed.
b If you switch the programme selector switch to "Sweeping",
the container flap opens automatically and the waste con-
tainer is ready to pick up waste.
3. Empty the waste container at regular intervals.
a If mainly chippings were swept up (heavy waste), empty the
waste container earlier.
4. When cleaning surfaces, set the programme selector to
"Sweeping with roller brush".
5. To clean side edges, also use the side brushes by setting the
programme selector switch to "Sweeping with roller brush and
side brushes".
6. Fixed obstacles up to 6 cm high can be driven over slowly and
carefully.
7. Drive over fixed obstacles of more than 6 cm in height with a
suitable ramp.
Sweeping with roller brush and side brush
1. For cleaning work, select the forwards direction of travel.
2. For surface cleaning: Lower the roller brush by setting the pro-
gramme selector to "Sweeping with the roller brush".
3. For wet or damp surfaces: Open the wet sweeping flap.
4. For cleaning close to the edge: also lower the right side brush-
es by setting the programme selector switch to "Sweeping with
roller brush and side brushes".
5. To pick up larger objects (50 mm): Briefly press the coarse dirt
flap pedal.
6. Clean the dust filter from time to time.
a The dust filter is automatically cleaned at regular intervals.
b In dusty environments, also press the filter cleaning switch.
Emptying the waste container
The high dumping system on the unit allows the waste to be di-
rectly emptied into a waste container (see chapter "Technical da-
ta" for maximum discharge height).
WARNING
Risk of injury due to falling objects!
When lifting and lowering the waste container, there is a risk of
injury from objects falling from the storage surface.
Before lifting the waste container, remove all objects that are not
securely fastened from the storage surface.
WARNING
Risk of injury due to tipping of the machine when emptying
the waste container!
Empty the waste container only on firm, level ground.
Maintain a safety distance when emptying on stockpiles and
ramps.
WARNING
Risk of injury when standing in the swivel range of the waste
container!
Make sure that no persons or animals are in the swivel range of
the waste container during the emptying process.
WARNING
Risk of injury due to crushing or shearing off of body parts
when reaching into the mechanics of the waste container!
Do not reach into the movement area or the components of the
emptying mechanism of the waste container.
WARNING
Risk of injury if the waste container falls!
The raised waste container can fall abruptly and cause serious in-
juries due to crushing and trapping.
Do not walk underneath the waste container if it is unsecured.
Secure the raised waste container properly with the supplied
safety brace before walking underneath the waste container.
High dumping button
1
Switch for raising/lowering the waste container
2
Open/close container flap switch
3
1. Set the programme selector switch to the "Drive" position (the
waste container can only be lifted in this position).
2. Roughly position the device.
a After switching off the device, wait at least 1 minute so that
the dust can settle before emptying.
3. Press the high discharge button on the control panel and keep
it pressed.
4. Press the waste container switch and raise the waste contain-
er.
a To empty it into a waste bin, lift the waste container com-
pletely and slowly move towards the collection container.
b For free emptying, lift the waste container approximately to
the middle until the container flap can be opened (if the emp-
tying height is too low, the operation of the container flap is
blocked).
5. Apply the parking brake.
6. Press the container flap switch and empty the waste container.
7. Close the container flap.
8. Release the parking brake.
9. Drive away from the emptying station.
10.Lower the waste container completely.

Switching off the device

The dust filter is automatically cleaned when the device is
switched off.
1 Park the device on a level surface.
2 Turn the programme selection switch to the "Drive" position.
3 Apply the parking brake.
4 Remove the key from the key switch.
5 Close the fuel cock.
DANGER
Risk of accident when loading
Always close the neutral lever when loading the device. Only then
are the drive and parking brake ready for operation. The device
must always be moved with its own drive on inclines or slopes.
Only load and unload devices on a level surface.
Risk of injury and damage
Note the net weight (transport weight) of the device when trans-
porting it on trailers or vehicles.
Secure the device in accordance with the respectively applicable
guidelines to prevent it from slipping or overturning.
English

Transport

27