Maintenance Schedule - Husqvarna 1-8DPF40 Bedienungsanweisung

Inhaltsverzeichnis

Verfügbare Sprachen

WARNING:

maintenance, stop the motor and disconnect

the power plug from the power supply. Make

sure that all drives stop.

For all servicing and repair work on the product, special

training is necessary. We guarantee the availability of

professional repairs and servicing. If your dealer is not

a service agent, speak to them for information about the

nearest service agent.

For more detailed information, refer to

www.husqvarnaconstruction.com.

General product maintenance

Make sure that nuts and screws

are tight.

Make sure that the power plug

and extension cable are in

good condition and not dam-

aged.

Do a check of the electrical

components, the cables and

the connections for wear and

damages.

Do a check of the RCD.

Examine the electric motor for

dirt and damage.

Make sure that the dust extrac-

tor hose is not damaged and

that there is no blockage.

Empty the dust extractor.

Do a check of the of the abra-

sive separator, the separator

tray and the feedspout.

Clean the product.

Do a check of all safety devi-

ces.

Do a check of the brush seal

and magnetic seal for wear.

Do a check of the control cage,

blastwheel and liners for wear.

To do before you oper-

Refer to

ate the product on page 9 .

Do a check of the v-belt ten-

sion.

Do a check of the drive chain

tension of the drive system.

Before you do the

Each 3 h