Maintenance; Maintenance Schedule - Husqvarna 2-20DT Bedienungsanweisung

To stop the product
1. Push the abrasive control lever to close the abrasive
To operate the abrasive valves on
valve. Refer to
page 13 .
2. Push the OFF button to stop the blast motors.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 7 .
WARNING:
maintenance, stop the motors and
disconnect the power plug from the power
source. Make sure that all drives stop.
General product maintenance
Make sure that nuts and screws
are tight.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
20

Maintenance

Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
3. Turn the ON/OFF switch to OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust extractor. Refer to the operator's
manual of the dust extractor.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after
Daily
service
* *
*
Each 3
Yearly
months
2037 - 002 - 06.04.2023