Husqvarna 1-8DPF40 Bedienungsanweisung Seite 15

3. Attach the dust extractor hose safely to the
connection for dust extractor. Connect the attached
parts with the supplied tool and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To do a check of the direction of
rotation of the motor
1. Start the product. Refer to
page 16 .
2. After some seconds, stop the product. Refer to
stop the product on page 19 .
3. Make sure that the blastmotor has the correct
direction of rotation. The correct direction is shown
with an arrow on top of the fan cover.
4. If it is necessary, change the direction of rotation
of the motor. Refer to
rotation of the motor on page 15 .
2124 - 001 - 13.04.2023
To start the product on
To change the direction of
To change the direction of rotation of
the motor
1. Turn the ON/OFF switch to the OFF position.
2. Wait until the product has fully stopped.
3. Disconnect the extension cord from the power plug
on the product.
4. Turn the inverter switch in the power plug on the
product to the opposite position.
To
5. Connect the power cord and do a check of the
direction of rotation of the motor. Refer to
check of the direction of rotation of the motor on
page 15 .
To select the correct speed
It is important to do the operation with correct drive
speed for best result. If the surface has different quality,
To do a
15