Husqvarna 1-8DPF40 Bedienungsanweisung Seite 13

To adjust the height of the magnetic
seals
1. Loosen the 2 adjustment screws at the rear wheels.
2. Loosen the 2 bolts (A) and turn the 2 adjustment
screws (B) to adjust the height.
3. Adjust the height until the magnetic seals are 8–10
mm from the surface.
4. Tighten the screws.
To adjust the height of the brush list
seals
The brush list seals wear when you operate the product.
It is necessary adjust the height of the brush list seals at
regular intervals.
2124 - 001 - 13.04.2023
1. Loosen the 2 screws that holds the brush list.
2. Adjust the height of the brush list until the brush list
A
B
3. Tighten the 2 screws.
Abrasive
Speak to your Husqvarna dealer for the selection of
correct abrasive for your surface operation. Refer to
Approved abrasive on page 28 .
is 1 mm above the surface.
13