Maintenance Schedule; Maintenance - Husqvarna 150BT Mark II Bedienungsanweisung

6. Tighten the chest strap.
7. Tighten the shoulder straps until the product is tight
against your body.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

Maintenance

Clean the external surfaces.
Make sure that the control handle operates correctly.
Make sure that the start/stop switch operates correctly. Refer to
the start/stop switch on page 5 .
Examine the engine, the fuel tank and the fuel lines for leaks. Examine the fuel
filter for contamination. Replace the fuel filter if it is necessary.
Clean the air filter. Replace the air filter if it is necessary.
Tighten nuts and screws.
Examine the air intake and make sure that it is not blocked.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages, cracks and deformation.
Make sure that the vibration damping units are correctly installed.
1456 - 002 - 06.05.2021
Maintenance
Read and understand the
8. Tighten the load lifter straps.
To do a check of
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
11