Husqvarna 1-8DPF40 Bedienungsanweisung Seite 22

3. Put an applicable tool in the blastwheel to prevent
rotation. Remove the bolt and discard it.
4. Remove the blastwheel.
5. Install the new blastwheel in the opposite sequence.
CAUTION:
when you install a new blastwheel.
6. Turn the new blastwheel manually. Make sure that
the blastwheel turns freely and does not hit the
control cage.
To do a check of the V-belt tension
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 19 .
22
Always use a new bolt
Do not operate the product
To stop the product on
2. Remove the V-belt cover.
3. Examine the V-belts for damages and wear. Replace
the V-belts if it is necessary.
4. Push the V-belts with your tumb to examine the
tension. If you can push the V-belts a distance of
10–15 mm (A), the tension is correct.
5. If the V-belts tension is not sufficient, increase the
distance between the motor and the bearing.
6. Install the V-belt cover.
To replace the V-belts
WARNING:
belt cover when the power supply is
disconnected and the blastmotor has fully
stopped.
WARNING:
without the V-belt cover installed.
1. Remove the V-belt cover. Refer to
the V-belt tension on page 22 .
2. Reduce the distance between the blastmotor and the
bearing to release the tension of the V-belts.
3. Remove the old V-belts and install the new V-belts.
4. Increase the distance between the blastmotor and
the bearing to apply tension to the V-belts. Refer to
To do a check of the V-belt tension on page 22 .
5. Attach the V-belt cover.
A
Only remove the V-
Do not operate the product
To do a check of
2124 - 001 - 13.04.2023