Husqvarna 1-8DPF40 Bedienungsanweisung Seite 26

WARNING:
rearward during operation.
WARNING:
steel toe-cap and non-slip sole.
1. Engage the drive system. Refer to
drive system on page 10 .
2. Set and adjust the movement speed with the speed
control dial (A).
B
A
3. Push and hold the drive system lever (D) to move
the product forward.
4. Push and hold the overdrive button (C) to move at
maximum speed.
5. Push and hold the rearward button (B) to move the
product rearward.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
• To move the product down a ramp, operate the
product forward slowly.
• To move the product up a ramp, operate the product
rearward slowly.
• Do not turn the product to the left or to the right more
than 45° on a ramp.
26
Do not move the product
Use protective boots with
To engage the
C
D
Be very careful when you
For ramps with a steep
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the work area.
WARNING:
product. Make sure that the lifting eye is
correctly installed and not damaged.
1. Attach the lifting equipment at the lifting points.
2. Lift the product safely. Hold the handle until the
product is lifted off the ground.
To attach the product to a
transportation vehicle
Use the lifting eyes to attach the product to the
transportation vehicle.
1. Attach the tie-down straps in the lifting eyes.
2. Attach and tighten the tie-down straps to the
transportation vehicle.
Storage
CAUTION:
storage outdoors. Always keep the product
indoors.
• Keep the product in a dry and frost-free area.
• Clean the product and do a complete servicing
before you put the product in storage.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Remove abrasive from the abrasive separator.
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
Do not put the product in
2124 - 001 - 13.04.2023