Transportation, Storage And Disposal - Husqvarna 1-8DPF40 Bedienungsanweisung

Problem
The product stops af-
ter a while.
The drive system
does not operate cor-
rectly.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
• Make sure that the power supply is disconnected
before transportation.
• Make sure that the electrical cable and dust extractor
hose are disconnected before transportation.
• Remove the abrasive before transportation.
• The wheels let you move the product shorter
distances. For longer distances, lift the product to
move it or put the product on a vehicle.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Engage the drive system during transportation. Refer
To engage the drive system on page 10 .
to
To move the product manually
WARNING:
are stationary before you move the product.
2124 - 001 - 13.04.2023
Cause
The motor protection switch releases be-
cause of overload.
The motor has a damage.
A safety fuse or a fault current breaker is on.
Cables are damaged.
The drive system is not engaged.
Safety fuse or the drive system motor is
damaged.
The control panel is damaged.
The potentiometer is damaged.

Transportation, storage and disposal

Be careful during
Do not tow the product
Wait until all moving parts
Solution
Speak to an approved Husqvarna service
agent.
Do a check of the motor.
Speak to an approved Husqvarna service
agent.
Do a check of the cable and replace if neces-
sary.
Install the quick-release pin.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
WARNING:
steel toe-cap and non-slip sole.
WARNING:
up and down ramps manually with the drive
system disengaged. Only move the product
manually on level ground.
1. Disengage the drive system. Refer to
the drive system on page 11 .
2. Push or pull the product by the handle.
3. Engage the drive system. Refer to
drive system on page 10 . With the motor off, this
has the function of a parking brake and prevents
accidental movement of the product.
To move the product with the drive
system
WARNING:
there is a risk of injury if the product falls. Be
careful when you move around the product.
WARNING:
the ground during operation.
Use protective boots with
Do not move the product
To disengage
To engage the
The product is heavy and
Do not lift the product of
25