Husqvarna 1-8DPF40 Bedienungsanweisung Seite 16

adjust the drive speed for an equal result. Examine the
result and adjust the speed if it is necessary.
• Turn the speed control dial clockwise to increase the
speed.
• Turn the speed control dial counterclockwise to
decrease the speed.
a) Use drive speed 6–10 on concrete surfaces for
light treatment.
b) Use drive speed 0–5 on concrete surfaces for
heavy treatment.
c) Use drive speed 0–2 on steel surfaces.
To start the product
1. Connect the product to a power supply. Refer to
connect the product to a power source on page 15 .
2. Start the dust extractor. Refer to the operator's
manual of the dust extractor.
3. Attach the dust extractor hose to the product. Refer
To connect a dust extractor on page 14 .
to
4. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
5. Set the ON/OFF switch on the electrical enclosure to
the ON position.
6. Engage the drive system. Refer to
drive system on page 10 .
16
7. Push the ON button to start the blastmotor.
8. Wait until the ammeter is in idle position.
9. Make sure that the direction of rotation of the
10. Turn the speed control dial to set the drive speed.
To
To operate the product
1. Make sure that the work area is safe. Refer to
2. Fill the abrasive separator with abrasive. Fill the
3. Start the product. Refer to
4. Engage the drive system. Refer to
To engage the
blastmotor is correct. Refer to
direction of rotation of the motor on page 15 .
WARNING:
operation only. Do not move the product
rearward during operation.
WARNING:
during operation. Abrasive comes out of the
product at high speed and can cause injury.
area safety on page 7 .
separator with abrasive when necessary. Refer to
fill the product with abrasive on page 14 .
page 16 .
drive system on page 10 .
To do a check of the
This product is for forward
Do not lift the blasthousing
Work
To start the product on
To engage the
2124 - 001 - 13.04.2023
To